0-30 Volt Laboratory Power Supply


Posted on May 29, 2012

The linear power supply, shown in the schematic, provides 0-30 volts, at 1 amp, maximum, using a discrete transistor regulator with op-amp feedback to control the output voltage. The supply was constructed in 1975 and has a constant current mode that is used to recharge batteries.


0-30 Volt Laboratory Power Supply
Click here to download the full size of the above Circuit.

A more modern circuit might use a single IC regulator, such as the MC78XX, or MC79XX series, immediately after the half wave rectifier, to replace approximately 30 components, or at least a high precision zener diode to replace D10 as the voltage referenc




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Single Chip FM Transmitter
variable Hartley oscillator
Automatic Tr Switch Circuit
Arduino Midi
sound activated lamp relay switch
arduino yogurt maker
Counters and Timer Circuits
Selfrunning Free Energy 5 KW Kapanadze 8
Reference time signal generation circuit 32.768kHz
Three-phase motor overcurrent protection circuit
RF Remote Control Switch Rx-Tx circuits



Top