Electronic Circuits Schematics Projects




5V transformerless Power Supply

Rating: 2.00/10 (36Votes cast)

Category: Power Supply Circuits / AC to DC & DC to DC
Views: 1316
Rank: 0

I use this power supply for applications that doesn't use too mucho power. It can provide power to circuit that uses less than 100mA without any problem. The disadvantage of this circuit is the danger of an electrical shock, so it cannot be used if the circuit is in contact with the user. The voltage supplied by this is determined by the zener diode. The version of the transformerless power supply that uses a bridge rectifier provides more current than the first one because it rectifies both phases of the AC voltage. Do not use it for 250VAC. It is dangerous! In fact, DO NOT BUILD THIS PROJECT. visit page.
5V transformerless Power Supply



Related circuits

Ac-To-Dc Converter

By coupling two back-to-back diodes in series with an ac power circuit, a voltage of about 1.4 Vpp can be obtained. This



Lsolated-converter

In this circuit. a negative output voltage de-de converter generates a -5 V output at pin A. In order to generate -5 Vat point A, the primary of the transformer must fly back to a diode drop more negative than -5 V. If the transformer has a tightly coupled 1/1 turns ratio, there will be a 5 V...



Power-Managed uC Power Supply

A power supply for PIC uControllers or other battery-operated electronics that require a +5-volt, regulated supply that can be gated off during periods of non-use. By depressing S1, the power supply is activated, supplying power to the uC. During its Power-on-reset processing the uC should...



12V - 24V Converter

This simple DC-DC converter can provide up to 24V from a 12V source. It can be used to run radios, small lights, relays, horns and other 24V accessories from a 12V vehicle with a maximum draw of about 800mA. It can be used to charge one 12V battery from another, or step up the voltage just enough...



Low-forward-drop-rectifier-circuit

A TMOS power FET, Ql, and an LM393 comparator provide a high-efficiency rectifier circuit. When V,. exceeds V,, Ul"s output becomes high and Ql conducts. Conversely, when VB exceeds V,., the comparator output becomes low and Ql does not conduct. The forward drop is determined by Ql"s on...



0-30 VDC Stabilized power supply with current control 0.002-3 A

This is a high quality power supply with a continuously variable stabilised output adjustable at any value between 0 and 30VDC. The circuit also incorporates an electronic output current limiter that effectively controls the output current from a few milliamperes (2 mA) to the maximum output of...



Precision-full-wave-rectifier

This circuit provides accurate full-wave rectification. The output impedance is low for both input polarities, and the errors are small at all signal levels. Note that the output will not sink heavy currents, except a small amount through the 10-K!J resistors. Therefore, the load applied should...



0-30 Volts / 2,5A Variable Power Supply

This is a high quality power supply with a continuously variable stabilized output adjustable between 0 and 30VDC. the LM 723 is the heart of the power supply which drives the BD137 and then the 2N3055. The circuit provides short circuit protection. And has great stability at voltage changes.




Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits