High-Voltage Pulse Supply


Posted on Oct 17, 2012

This high-voltage pulse supply will generate pulses up to 30 kV. Ql and Q2 form a multivibrator in conjunction wi


High-Voltage Pulse Supply
Click here to download the full size of the above Circuit.

th peripheral components Rl through R6 and CI, C2, C3, C5, C6, and D2. R9 adjusts the pulse repetition rate. R2 should be selected to limit the maximum repetition rate to 20 Hz. II is a type 1156 lamp used as a current limiter. R9 can be left out and R2 selected to produce a fixed rate, if desired. Try about 1 as a start. Q3 serves as a power amplifier and switch to drive Tl (an automotive ignition coil). NE1 is used as a pulse indicator and indicates circuit operation. Because this circuit can develop up to 30 kV, suitable construction techniques and safety precautions should be observed.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Cash Register circuit
16-300 MHz Testing Colpitts oscillator
FM Transmitter circuit using 2N2222
2 x 22W-BTL Car Audio Amplifier DA1553CQ Schematic Diagram
ethernet Poor eye diagram where to start looking
10 band equalizer
Cmos Based Vehicle Anti-Theft Alarm
ADUC845 12MIPS 8052 Flash MCU + 10-Ch 24-Bit ADC + 12-Bit DAC
Hv440: High Voltage Ring Generator
TWO QUADRANT
Voice Link Over Spread Spectrum Radio
Linear-Circuits in U.H.F. Oscillators
555 Composition with Watchdog circuit
By the driving capacitive loads MAX4223 ~ MAX4228 circuit diagram
Schmitt trigger light



Top