Isolated-feedback-power-supply


Posted on May 6, 2012

The diagram is a power supply circuit using the isolated feedback capabilities of the TL3103 for both current and voltage sensing. This supply is powered fromthe ac power line and has an output of 5 Vat 1.5 A. Both output voltage and current are sensed and the error voltages are applied to the error amplifiers of the TL594 PWM control !C. The 24-V transformer produces about 35 Vat the 1000-I`F filter capacitor. The 20-kHz switching frequency is set by the 6-KO resistor and the 0.01-I`F capacitor on pins 6 and 5, respectively.


Isolated-feedback-power-supply
Click here to download the full size of the above Circuit.

The TL594 is set for push-pull operation by typing pin 13 high. The 5-V reference on pin 14 is tied to pin 15, which is the reference or the current error amplifier. The 5-V reference is also tied to pin 2 which is the reference for the output voltage error amplifier. The output voltage and current limit are set by adjustment of the 10-KO pots in the TL3103 error-sensing circuits. A pair of TIP31E npn transistors are used as switching transistors in a push-pull circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

TONE CONTROL AND SUBWOOFER OUT
Loudspeaker Protection circuit
Regulated-driven-converter
motor control
QRD1114IR Sensor
wein bridge sine wave oscillator lm101
555 timer IC Inverter circuit schematic 12V to 220V
Model 300 Receiver
Help in identifying the schematic symbol
Puxing 777 Radio Headset Schematic
Salt bath resistance furnace temperature control circuit
Which only uses the 5V power supply connection circuit



Top