Electronic Circuits Schematics Projects




Smart Battery Charging with COP8ACC

Rating: 4.00/10 (26Votes cast)

Category: Power Supply Circuits / Chargers
Views: 5023
Rank: 0

Figure 1 shows a block diagram of the single slope, comparator based A/D converter. Using this approach an A/D converter can be configured by using only a single external capacitor. This capacitor provides the designer flexibility in controlling the resolution and conversion time.The external capacitor should be grounded on one side, and the positive terminal should be reset to 0V by momentarily shorting the capacitor through software control. An internal VCC/2 reference can be used to calibrate the A/D conversion. For a more visit page.

The external capacitor should be grounded on one side, and the positive terminal should be reset to 0V by momentarily shorting the capacitor through software control. An internal VCC/2 reference can be used to calibrate the A/D conversion. For a more http://www.national.com/an/AN/AN-1075.pdf

Related circuits

Battery Charger

Using this circuit will give Good Charging results to the Gell Cell Battery used in the Metal Detector, or any other simular and smaller type battery. This charger is both Current and Voltage Regulated.



Simple ni-cad battery charger

This circuit provides an adjustable output voltage up to 35 Vdc and maximum output current of 50 mA



Buck-converter charger

The design in Figure 1 uses two simple-switcher buck converters. The first regulator, IC1, efficiently steps down the unregulated input voltage from the rectifier`s output. This buck converter generates the input voltage for the battery and provides voltage to the second regulator. The second...



Car Battery Charger

This very simple circuit uses a transformer ,two diodes , a capacitor and an ammeter. To charge a battery just connect the + and - terminals of the circuit to the corresponding terminals of the battery. When the battery is not charged, the ammeter reading shows 1-3 amps. When the battery is...



Single Cell Lithium-ion battery charger

The rechargeable Li-ion, I began to intensely interested last summer, when I managed to bring a holiday without a phone charger. After several experiments involving originated in Figure 1, which has proved. Involvement of the stage provides a limited current charging and constant voltage....



High Efficiency Lithium-Ion Battery Charger

The LT®1510 current mode PWM battery charger is the simplest, most efficient solution for fast charging modern rechargeable batteries including lithium-ion (Li-Ion), nickelmetal- hydride (NiMH) and nickel-cadmium (NiCd) that require constant current and/or constant voltage charging. The...



Simple Lead Acid Battery Charger

The above pictured schematic diagram is just a standard constant current model with a added current limiter, consisting of Q1, R1, and R4. The moment too much current is flowing biases Q1 and drops the output voltage. The output voltage is: 1.2 x (P1+R2+R3)/R3 volt. Current limiting kicks in when...



Car Battery Charger

This Charger Can't be used as a Power Supply, Without having a battery in place. The Battery MUST be Connected to get power out. Note: This Charger Features a Reverse polarity Indicator. Instructions: Before plugging this charger into the 110 volt line (or turning it on if you use a Switch),...



How to charge Perkso M5000 Power Bank

Universal Battery Charger


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits