Positive And Negative Voltage Switching Supply

  
An LT1172 generates positive and negative voltages from a 5-V input. The LT1172 is configure
Positive And Negative Voltage Switching Supply - schematic

d as a step-up converter. To generate the negative output, a charge pump is used. C2 is charged by the inductor when D2 is forward-biased and discharges into C4 when LT1172`s power switch pulls the positive side of C2 to ground.



Recommended videos


  • How to Get Positive
     
  • Julian builds: a Split Voltage Power Supply (+/-12v and 5v)
    Duration: 7:41.
  • EEVblog #90 - Linear and LDO regulators and Switch Mode Power Supply Tutorial
    Duration: 17:04.

News


  • Electronics EETimes (registration)
    Electronics EETimes (registration) industryThe overall market for AC/DC and DC/DC commercial (C-), which excludes consumers and uninterruptible (UPS), is estimated to be worth between 22 and 25 billion US Dollars. The market has been s
     23 February 2017
  • Highland Mirror
    ... into multiple applications, including exciting alternatives in ighter and more-tunable light for general illumination, backlighting for more-vivid displays, optimized power management for high-current and variable-speed
     23 February 2017
  • TopChronicle
    ... into multiple applications, including exciting alternatives in ighter and more-tunable light for general illumination, backlighting for more-vivid displays, optimized power management for high-current and variable-speed
     22 February 2017
  • Engineer Live
    The device is employed in an array of electronic devices and equipment, including high voltage regulated , power supplies, UPSs, AC-DC adapters/chargers, DC-DC converters, lighting circuits, industrial ballasts, temperature and ...<
     21 February 2017
  • Hackaday
    They are AM receivers from an era with a low electrical noise floor, so they don't react well to high-frequency . Thus, the inverters usually tasked for projects like this are low-frequency, at 50Hz as this is a European
     20 February 2017
  • ThomasNet News (press release) (blog)
    ThomasNet News (press release) (blog) Used in , UPSs, DC-DC converters, lighting circuits, industrial ballasts and motor speed control circuits, SD560B Rectifier is designed with 5 A IO rating, 600 V VRRM and 200 A IFSM rating. Minimizing rev
     13 February 2017
  • ThomasNet News (press release) (blog)
    ThomasNet News (press release) (blog) Reducing start-up loss, CRD-060DD17P-2 Demonstration Board is operated in 300 V to 1000 V input voltage range. Delivering 48W of power, unit is designed with 1700 V SiC MOSFET. Suitable in auxiliary and
     13 February 2017
  • Hackaday
    Hackaday That's a total current requirement of almost 125 amps at 5 V. Add in all the Arduino's, and [Robert] needed a beefy 750 W of power, supplied via four . Each Arduino Nano is a slave on the I²C bus. The I²C master is an Ardui
     11 February 2017
  • Electropages (blog)
    Electropages (blog) designed for harsh environmentsPowersolve has a new family of encapsulated AC/DC designed specifically for harsh environments. Typically these will include security, CCTV and LED installations. For maximum applicatio
     8 February 2017

.