880MHz low-noise amplifier application circuit composed of RF2347


Posted on Mar 28, 2007

As shown in FIG constituted by 880MHz RF2347 low noise amplifier application circuit. Radio frequency (RF) signal from the input pin 3, after the output of the amplifier 7 feet


880MHz low-noise amplifier application circuit composed of RF2347
Click here to download the full size of the above Circuit.

. 3 feet and the internal amplifier is directly coupled, so 3 feet plus a 22pF blocking coupling capacitance, impedance matching at 836MHz work as 50. 7 feet for the open collector output terminal can be connected to the power supply Vcc through choke or matching inductor, the pin impedance matching is typically 50, external output matching network allows the amplifier output impedance matching for maximum output power and efficiency. 1 foot for the power down control terminal for controlling bias. When VPD (2.8 0.1) V when (IPD is typically 8.5mA) circuit; when VPD 0.9V circuit closes; VPD requested additional RF bypass circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Digital Automatic Level Control (Alc) Circuit
Triac regulation of mains voltage
switch mode power supply design of current load sense circuit
Triac Testing Circuit PCB
Inductor saturation tester alternative route to dump the excess energy
Light Activated Relay with 555 Circuit
Guitar Amplifier
Arduino Thermostat
Common emitter amplifier input and output signals of the phase relationship
Thermostat with three-wire serial interface smart temperature sensor DS1620 configuration control circuit



Top