Electronic Circuits Schematics Projects




stable guitar FM transmitter

Rating: 3.00/10 (85Votes cast)

Category: RF Circuits / FM Transmitter
This circuit is also crossed to: , FM radio
Views: 3813
Rank: 0

This FM transmitter has a number of features, with a volume control to adjust the input level and a small, neat box to make it easier to attach to a guitar. The volume control is positioned at the end and when turned up fully, the transmitter provides fuzz (distortion).The circuit takes the signal from a guitar, radio or tape-recorder and injects it into an oscillator operating at 90MHz. This produces a carrier frequency - also called a Radio Frequency (RF). This frequency is capable of being radiated to the surroundin visit page.

The circuit takes the signal from a guitar, radio or tape-recorder and injects it into an oscillator operating at 90MHz. This produces a carrier frequency - also called a Radio Frequency (RF). This frequency is capable of being radiated to the surroundin http://www.talkingelectronics.com/projects/BeetleMklll/BeetleMkIII.html

Related circuits

Long range FM transmitter

The transmitter circuit described here has an extra RF power amplifier stage, after the oscillator stage, to raise the power output to 200-250 milliwatts. With a good matching 50-ohm ground plane antenna or multi-element Yagi antenna, this transmitter can provide reasonably good signal strength...



Wireless-fm-microphone

Adjustable capacitor C10, and coil L1 form a tank circuit that, in combination with Q1, C2, and R1, oscillates at a frequency on the FM band. The center frequency is set by adjusting C10. An electret microphone, M1, picks up an audio signal that is amplified by transistor Q2. The audio signal...



2 Transistor FM Voice Transmitter

Take care with transmitter circuits. It is illegal in most countries to operate radio transmitters without a license. Although only low power this circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres.



Stereo PLL FM transmitter

This is the latest BH1417 FM Transmitter design from RHOM that includes a lot of features in one small package. It comes with pre-emphasis, limiter so that the music can be transmitted at the same audio level, stereo encoder for stereo transmission, low pass filter that blocks any audio signals...



Bug FM Transmitter

The circuit is basically a radio frequency (RF) oscillator that operates around 100 MHz. Audio picked up and amplified by the electret microphone is fed into the audio amplifier stage built around the first transistor. Output from the collector is fed into the base of the second transistor...



Fm Stereo Transmitter Circuit

A BA1404 IC is used to generate a complete FM MPX signal. The chip contains all of the necessary circuitry. CI and R3, and R4 and C4 provide pre-emphasis. The transmitter runs on a single AA cell. L3 is 3 turns of #20 wire on a Ke drill (for a form). L3 is long. L4 is 4 turns #20 wire on `Me...



500mW FM transmitter

The TX500 is a simple to build 500mW FM Transmitter. It consists of three blocks; modulator / oscillator, two stage 500mW VHF amplifier and LED based power meter. The TX500 allows to transmit audio signals to FM band at frequencies from 88 MHz to 108 MHz. Due to the very low power consumption of...



AVR Microcontrolled PLL FM Transmitter

An LMX1601 Phase locked loop, a discreet FET VCO, and an AVR micro controller combine to make a stable, easy to use monophonic FM transmitter that includes a an audio activated switch that turns the transmitter on only when its being used. The common characteristic of all of the previous low...



Articles & Projects
BA1404 5W FM Transmitter Circuit. Circuit with a few components, only four to form a miniature wireless FM microphone, a more stable operating frequency, firing range of more than 10 meters, 1.5V supply, the current less ...

It is designed to use an input from another sound source (such as a guitar or microphone), and transmits on the commercial FM band - it is actually quite powerful, so make sure that you dont use it to transmit anything sensitive - it could easily be picked up from several hundred metres away. The...

This is very stable, harmonic free, long range fm transmitter circuit which can be used for fm frequencies between 88 and 108 MHz. This can cover 5km range (long distance). It has a very stable oscillator because you use ...

Quality FM transmitter circuit. This house FM transmitter for your stereo or any other amplifier provides a good signal strength up to a distance of 500 meters with a power output of about 200 mW. It works off a 9V battery. The audio-frequency modulation stage is built around transistor BF494 (T1...

stability for its size. The battery supply rails have been well tied together. with respect to radio frequencies (C1, C2 and C7.) The. tracks are also thicker. This makes the circuit a single. 'solid' block eliminating RF currents in different parts ... Open Circuit.) R2 = 470K - Magnetic guitar ...

1.5 Volt Tracking FM circuit (Tracking Transmitter). Circuit Description 1.5 Volt Tracking FM (Tracking Transmitter). For stability, use a NPO types for C2 & C4. Tolerance for R1 should be 1 or 2%. Frequency range is usually ...

Beacon Light Simulation Using Basic Transistor Circuit

Easy creating of a printed circuit board using Fritzing


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits