Video/Audio Wireless Transmitter

Rating: 2.00/10 (70Votes cast)

Category: RF Circuits / RF Transmitters
Views: 2657
Rank: 7

In this fast-paced world, there is little time for inconveniences and a greater need for portability and adaptability. The idea for an Audio/Video transmitter stems from this need. There may have been times when you`ve wanted to hook up your VCR from one room to another television set in another room. But that would have entailed that you first unhook all kinds of wires and plugs from the primary TV set; carry the VCR to the next TV set; and then finally re-wire everything together. An Audio/Video transmitter will let you do just about the same thing. But it would offer other conveniences as well. For example, it would allow you to set up security cameras around your home which would send video signals directly to a TV or VCR. And, there are no cumbersome wires and cables to line throughout the intended area. visit page.

Related circuits

50MHz Transmitter alarmer with PIC16F84

This project is about an IR-detector (Infra Red) combined with a 100mW 50MHz transmitter. The detector is sensitive to changes in IR-spectrum and is commonly used in burglar alarms. When the detector sens a person/animal/ghost/angry clown, it will transmitt a warning signal to a portable...

RF-telemetry transmitter features minimal parts count

Requirements for portable, short-range telemetry systems frequently include low power consumption, small size, and low cost. The circuit in Figure 1 meets these criteria and uses only three off-the-shelf ICs and a few passive components. Although dedicated to conditioning the low-level signal a...

1W-cwtransmitter

This is a little transmitter that could be put into a plastic Easter egg. It delivers approximately 1 W of measured rf output into a 50-0 dummy load, and creates no heating problems with the circuit. The crystal is a series fundamental type, and the power source provides 9 V with a 2-A supply....

1.5v tracking transmitter

The circuit is a common form used in FM transmitters. The transistor conducts for 60-90 electrical degrees. When it turns off the LC tank `rings`, completing the sinusoidal waveform coupled to the antenna. The circuit is 77-85% effecient, compared to 40-50% for a linear oscillator.

Gate Deep Oscillator

It`s just a variable oscillator based on a bf245 or k 161 fet. By changing the coil it can generate frequency between 0.5 and 300 MHZ. this circuit is useful to test radio circuit such as filter, receiver, transmitter and so on . It can be use for coil tuning thanks to the 100microA meter .It...

Radio Remote Control using DTMF

Here is a circuit of a remote control unit which makes use of the radio frequency signals to control various electrical appliances. This remote control unit has 4 channels which can be easily extended to 12. This circuit differs from similar circuits in view of its simplicity and a totally...

Infra/radio remote control transmitter/receiver with PIC

This is a general purpose remote control project with using programmable PIC microcontrollers. Schematics are shown for using infrared (RF) or radio (RF) media. If you are not familiar with microcontroller programming, you can use fixed encoder and decoder integrated circuits instead. Well-known...

30 Meters CW transmitter

This transmitters' intended purpose is for morse-code only in the 30 meter band (10Mhz). It is a low-power QRP type and needs to be connected to your existing tranceiver. The harmonic rejections on the prototype were measured at 40dB on 20Mhz and 50dB on 30Mhz. The transmitter is build as a...

2.4G 2W Wireless Audio Video Transmitter and Receiver High Power and Long Dis...