Automatic distress alarm kit control circuit


Posted on Nov 10, 2015

Circuit works: When the patient usually upright, packed in kit SQ mercury switch was turned off,


Automatic distress alarm kit control circuit
Click here to download the full size of the above Circuit.

the alarm circuit power does not work. Once the patient down, SQ automatically connected to the power supply circuit, GB by RT, charges C, after a few seconds about the charging voltage across C up to about 1.3 V, VD and VT. Successively by the cutoff turned ON, lC by 7 feet to get low-level trigger signal work, the output of the pulse output of 6 feet three frequency conversion signal, the VT2 power amplifier, the drive B issue a pleasant change tone alarm .




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

13.8V/40A Stabilized high Power Supply
More debugging of the NRI 832
50MHz 10mW handy transceiver
1999 Pontiac Montana: console temperature MPG compass etc. failed
RC Audio Oscillator
Low power monostable circuit diagram
Automatic level control circuit diagram of the four
Zero sequence voltage phase protection circuit 2



Top