alarm using PIC16F628-04


Posted on Nov 27, 2012

This article describes a 2-Input alarm developed on the PIC LICK-1 Module using a Microchip PIC16F628-04. The program uses the internal 4MHz oscillator and if any other frequency is used, the timer values will need to be changed. A two zone alarm means the system has two separate detection circuits and can identify which circuit was triggered. The circuit uses lines RA1 and RA2 as zone 1 and zone 2. The operator can only enable or disable Zone 2.


alarm using PIC16F628-04
Click here to download the full size of the above Circuit.

This allows situations such as disabling a large zone such as the garage, while an ultrasonic detector covering a smaller zone, such as toolboxes or equipment, remains enabled. A more practical application would be in a small store with a workroom at th




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Square-Wave Oscillator
Counter 0-9 Using Arduino Microcontroller
tuned sine wave oscillator circuit
gsm gps based vehicle theft control
TB6556FG 3-Phase Full-Wave Sine-Wave PWM Brushless Motor Controller
TWO QUADRANT



Top