Electronic Circuits Schematics Projects




SINGLE IC FORMS SENSITIVE MODULATED LIGHT RECEIVER

Rating: 9.00/10 (31Votes cast)

Category: Sensors Detectors / Light Sensing Circuits
This circuit is also crossed to: , Lighting
Views: 5287
Rank: 0

The circuit uses a very inexpensive C-MOS IC that is connected to a small photodiode. Using a unique inductive feedback network, the circuit provides high sensitivity under high ambient light conditions. It is a great circuit when you want to extend the range of an optical remote control transmitter. visit page.

Related circuits

Sun-tracker

In solar cell array applications and solar instrumentation, it is desirable to monitor the approximate position of the sun to allow efficient automatic alignment. The Ll4Gllens can provide about 15° of accuracy in a simple level sensing circuit, and a full hemisphere can be monitored with...



Latching light detector is frugal with power and parts

This idea demonstrates three uses for the humble LED. The circuit in Figure 1a forms a simple light detector that latches and turns on an LED when the ambient light exceeds a preset limit determined by potentiometer P1. LED D1 is both the indicator and the light detector. All junction diodes...



Porch Light Control Circuit

This circuit can control the on/off cycle of a light via a CDS photocell, and turn it off after a preset period. The light can only be turned on when CDS cell is in darkness, and it stays on for a time determined by the 555 circuit.



Light-controlled-lamp-switch

A school drama needed lamps that automatically turned on and off when spot lights did the same. Lamp switching had to be wireless, durable, dependable, simple and inexpensive. With stage and spot lights off, very little light falls on the CdS photocell, so its internal resistance is several...



Constant-brightness-control

An automatic control maintains a lamp at a constant brightness over a wide range of supply voltages. This circuit utilizes the consistency of photodiode response to control the phase angle of power line voltage applied to the lamp and can vary the power between that available and "" 30% of...



Light Pollution Meter

My circuit adds a transistor, to add feedback, and two resistors, to tailor the range of the control, with the result that a single-turn potentiometer gives a control range of about 2 to 30 microamps. I installed my circuit in a small plastic box, and mounted banana plugs on the bottom of the box...



Across The Track Infrared Detectors

This page presents information on infrared - `Across The Track` train detection circuits. The circuits are designed around the LM339 comparator chip and can use a wide assortment of matched infrared - emitter / detector pairs. The basic circuit shown below has been tested with sensor gaps as wide...



BROAD BAND 2MHz OPTICAL FIBER RECEIVER

If you need more sensitivity than the above circuit this circuit provides about ten times more gain. It too is designed around an inexpensive plastic optical fiber detector.




Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits