Power Buffer Boosts Reference Current


Posted on Sep 3, 2012

A method of boosting the output current of a reference and also protecting against overloads is shown


Power Buffer Boosts Reference Current
Click here to download the full size of the above Circuit.

in Fig. 66-5. IC1 acts as a power buffer. The LT1027 forces the output of V0ut and ground to be 5 V. The RC damper (50 and 0.1 ¥) provides loop stability. The output might oscillate if low ESR capacitors are connected to it, so use aluminum electrolytic or tantalum capacitors instead of ceramic or mylar.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

20kV Flyback power supply
IR remote control transmitter-receiver
5 Minute Signal
Balanced Microphone Preamplifier
Communication between a USB/serial device and an AVR (atmega/Arduino) microcontroller
arduino Switch transistor with a low voltage and current
make this simple delay on circuit
infrared remote control tester
Audio Oscillators
working principles of motor control
Dodd Station
Light illuminated control circuit



Top