Flash Camera into a Self-Repeating Strobe


Posted on Apr 17, 2012

The first step is to remove the film. Be sure the film is fully wound in. Then use a flat blade screwdriver to pry up the tab at the seam in the middle of the right side of the camera. The right side of the rear panel of the camera should then pop up. You can swing this part open to get the film. This is ordinary enough Kodak MAX 35 mm. color print film ready for processing.






Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Yelping-siren
The STA013 MP3 Decoder Chip
circuit to test servo motor (pole rotor) of parabolic antenna
High voltage generator excitation set overvoltage protection circuit
Electronic circuit diagram of frostbite treatment device



Top