1000:1 Tuning Voltage-Controlled Filter


Posted on Sep 14, 2012

A standard dual integrator filter can be constructed using a few CA3080s. By varying LABC, the reso


1000:1 Tuning Voltage-Controlled Filter
Click here to download the full size of the above Circuit.

nant frequency can be swept over a 1000:1 range. At IC1, three are current-controlled integrators. At IC2, four are voltage followers that serve to buffer the high-impedance outputs of the integrators. A third CA3080 (IC5) is used to control the Q factor of the filter. The resonant frequency of the filter is linearly proportional to /abc· Hence, this unit is very useful in producing electronic music. Two outputs are produced: a low-pass and a bandpass response.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Automatic Level Control Signal Circuit
Mains-Powered Timer
Loudspeaker Protector Circuit
Motorola SN54 Demultiplexer Logic Diagram and Datasheet
High Input Voltage regulator using LM340
Expandable Graphic Equaliser
the water-saving irrigation system design of ZigBee wireless sensory network
OpAmp based Voltage Translator Ciruit for ADC of Micro-controller
Electret microphone amplifier circuit design using transistors
MOSFETs and CMOS Inverter
Frequency Multipliers
Low-Power Voltage Reference
regenerative radio receivers
Pocket-sized device to help Xin
Practical digital amplifier TL084



Top