Serial MIDI Interface


Posted on Oct 27, 2012

This page describes how to build this full-bandwidth single-port (one input and one output) MIDI interface. The interface is buffered (that is, if the PC gets behind you won`t lose data) and it works in Windows 3.1 and Windows 95 using a special (and very well-behaved) device driver. A simpler version, using an Atmel AT89C2051 microprocessor, is described here.


Serial MIDI Interface
Click here to download the full size of the above Circuit.

Some specifications: MIDI input buffer size: 124 bytes Baud rate to/from PC: 38,400 baud Processor: 80C51/87C51 Can be built using either external EPROM or single-chip processor. Powered by PC serial port. EPROM version may require an optiona




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Car Battery Charger
    Three phase tester
    1 Watt 2.3 ghz amplifier
    2 x 60 W audio amplifier circuit
    High-intensity LED Warning Flasher
    Moduler Preamplifier Circuit
    LF353 JFET-INPUTDUAL OPERATIONAL AMPLIFIER
    1995 camaro: just swapped the engine/ trans with cradle wheel well
    SOLAR BATTERY CHARGER CIRCUIT WITH OVER CHARGE PROTECTION
    RAZOR SHARP CW FILTER
    High-performance DC amplifier driving circuit AP500A-01
    Complementary symmetry push-pull circuit



    Top