LMD18400 for four-phase stepper motor drive


Posted on Dec 11, 2010

DMOS power switch ON-state resistance has a positive temperature coefficient, four switches can be arbitrarily parallel to increase the load current, and therefore a monolithic


LMD18400 for four-phase stepper motor drive
Click here to download the full size of the above Circuit.

LMD18400 can drive one, two, four small DC motor. From the PWM control signal input terminal can be implemented now motor speed control, shown in Figure 11-12 and Figure 11-13. LM1951 is a high speed f of 50kHz) the high-side intelligent switching. It therefore provides the following fault protection and fault indication output: Output is shorted to ground or short to power on the positive and negative holy open circuit, over current, over voltage, over temperature. It is suitable for resistive and inductive load drive, 30V output is clamped inductive load make rapid discharge, the input control terminal of the TTL/( MOS compatible with ESD (Antistatic) protection.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Phase indicator
+15-V-1-a-regulated-power-supply
2 GHz CMOS Voltage-Controlled Oscillator with Optimal Design of Phase Noise and Power Dissipation
Light control system of traffic of double mode of infrared remote-control on the basis of 89C52 one-chip computer
Adjustable 1-10 Minute Timer Project
Low Voltage to 30 kV Out



Top