High-Power Car Audio Amplifier


Posted on Dec 28, 2012

NOTE: FOR BRIDGE CONFIGURATION: t install jumpers ju2 and ju4 2.remove j 1)3 3.remove rio 4replace


High-Power Car Audio Amplifier
Click here to download the full size of the above Circuit.

r13 with jumper wire 5replace ri5 with 4.53k ohm 1% 6. replace r14 with 1 13k ohm 1% 7 cut foil between pads from rh and ground 8.input becomes left channel input 9.take ( output from left output 10 takf output from right output This stereo amp will supply 60 W rms into 8 or 100 W rms into 4 . Notice that the LM12C1 line level (about 300 mV) into 5 . A ±35-V supply is required for full power output. Power can be obtained from a dc-dc converter.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Rangkaian Thermometer Berbasis Mikrokontroler AT89S52
power failure alarm circuit
0-44dB RF Attenuator circuit with RF 2420
CMX7031Q1 The Two-Way Radio Processor
Introduction



Top