120VAC Lamp Chaser circuit


Posted on Feb 5, 2014

This circuit is basically the same as the channel LED sequencer with the addition of solid state relays to control the AC lamps. The relay shown in the diagram is a Radio Shack 3 amp unit (part no. 275-310) that requires 1.2 volts DC to activate. No current spec was given but I assume it needs just a few milliamps to light the internal LED. A 360 ohm resistor is shown which would limit the current to 17 mA using a 9 volt supply..


120VAC Lamp Chaser circuit
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    10 Band Audio Equalizer
    Variable Square wave oscilator with 555 circuit
    Low Cost Water Pump Controller Circuit
    Loudspeaker Protector Monitors Current
    OP AMP BASED MONOSTABLE MULTIVIBRATOR 741
    When using the lamp base circuit delay circuit 2



    Top