Basic UPS Power Supplys


Posted on Feb 7, 2014

This circuit is a simple form of the commercial UPS, the circuit provides a constant regulated 5 Volt output and an unregulated 12 Volt supply. In the event of electrical supply line failure the battery takes over, with no spikes on the regulated supply. This circuit can be adapted for other regulated and unregulated voltages by using different re


Basic UPS Power Supplys
Click here to download the full size of the above Circuit.

gulators and batteries. For a 15 Volt regulated supply use two 12 Volt batteries in series and a 7815 regulator. There is a lot of flexibility in this circuit. TR1 has a primary matched to the local electrical supply which is 240 Volts in the UK. The secondary winding should be rated at least 12 Volts at 2 amp, but can be higher, for example 15 Volts. FS1 is a slow blow type and protects against short circuits on the output, or indeed a faulty cell in a rechargeable battery. LED 1 will light ONLY when the electricity supply is present, with a power failure the LED will go out and output voltage is maintained by the battery. The circuit below simulates a working circuit with mains power applied: Between terminals VP1 and VP3 the nominal unregulated supply is available and a 5 Volt regulated supply between VP1 and VP2. Resistor R1 and D1 are the charging path for battery B1. D1 and D3 prevent LED1 being illuminated under power fail conditions. The battery is designed to be trickle charged, charging current defined as :- D2 must be included in the circuit, without D2 the battery would charge from the full supply voltage without current limit, which would cause damage and overheating of some rechargeable batteries. An electrical power outage is simulated below: The ability to maintain the regulated supply with no electrical supply depends on the load taken from the UPS and also the Ampere hour capacity of the battery. If you...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    VHF FM transmitter
    Microprocessor triac array driver
    Electronic bongos
    Latching Continuity Checker
    Wein Bridge Oscillator using ic 741 op amp
    Sp6648 Flashlight Application
    mosfet voltage regulator
    Car Headlights Timer Circuit
    running lights brake light to work but not the turn signal harness
    5x7 dot matrix circuit
    Has 50 times the pre-amplified bridge circuit diagram XTR106
    D2025 dual-channel audio amplifier circuit diagram



    Top