FET based audio preamplifier


Posted on Feb 5, 2014

This is the circuit of a based audio preamplifier which has very low noise. One FET and one BJT are used in this circuit. The audio signal to be amplified is coupled to the base of FET Q1 using capacitor C1 and resistor R3. Base of transistor Q2 is coupled to the drain terminal of FET Q1. Transistor Q2 provides additional current gain. The final si


FET based audio preamplifier
Click here to download the full size of the above Circuit.

gnal will be available at the collector of Q2. Capacitor C3 provides necessary negative feedback, which improves stability. Capacitor C2 is an output DC decoupling capacitor. Since an FET is used in the input stage this particular amplifier circuit has very high band width (10 KHz- 450 KHz) and input impedance (around 1M).




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

60W Power Amplifier with 2N3055
Light Detector
Super-Simple Shortwave Receiver Circuit
ADC Tester (A2100)
MiniVol PGA2320 Volume Control
gps receiver for kenwood tm d710e
Dual level liquid sensor circuit design using CA3410 op amp
LM386 Audio Amplifier



Top