Fluid lever sensor circuit design using ac signal


Posted on Feb 6, 2014

This fluid level sensor circuit is designed for using an ac sensing signal to eliminate electrolytic corrosion on the probes. The ac signal rectified is used to drive T1 transistor that drives a 12 volt relay, that can activate or stop some device. R2 resistor is used to modify the sensor sensitivity and can be replaced with a small variable res


Fluid lever sensor circuit design using ac signal
Click here to download the full size of the above Circuit.

istor. MC104093B is a p channel quad 2 input NAND schmitt trigger and is pin to pin compatible with the CD4093. The unused inputs must be tied to an appropriate voltage level, either ground or +12 volts (8, 9, 12 and 13) and the unused outputs must be left open (10 and 11).




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    6V to 12V Converter
    Divide-By-N + 1/2 Circuit
    60 LED Clock
    a single transistor smart battery charger
    Simple Over Voltage Protection Circuit: High Voltage Cut Off
    ASTABLE BLOCKING OSCILLATOR
    136 kHz QRSS receiver
    1.8MHz AM transmitter and receiver
    lights 5GM168 control circuit diagram
    IR2110 for forward inverter system schematic
    Intelligent Ultrasonic Ranging IC 4Y4 form a monolithic liquid crystal display rangefinder circuit diagram
    Three temperature switch circuits



    Top