Fridge Door Alarm Schematic 2nd Version


Posted on Feb 6, 2014

The main purpose of this design was to obviate a small defect of the very popular Fridge Door Alarm circuit, available on this website since 1999 and built by a lot of hobbyists. Unfortunately, that circuit stops operating when the battery voltage falls below about 2. 6 2. 7 Volts. This is due to the 4060 CMos IC used. In some cases, devices mad


Fridge Door Alarm Schematic 2nd Version
Click here to download the full size of the above Circuit.

e by some manufacturers (but not Motorola`s) fail to operate even at nominal 3V supply voltage. A simple cure to this shortcoming could be the substitution of the original IC specified with a 74HC4060 chip: this should allow circuit operation down to 2V but, unfortunately, this IC is not easy to locate. For this reason, an equivalent circuit using about the same parts counting was developed, in order to allow safe operation even when battery voltage falls down to about 1. 3V. The circuit, enclosed in a small box, should be placed in the fridge near the lamp (if any) or close to the opening. With the door closed, the interior of the fridge is in dark, the photo resistor R2 presents a high resistance (>200K) thus clamping IC1 by holding C1 fully charged across R1 and D1. When a beam of light enters from the opening, or the fridge lamp lights, the photo resistor lowers its resistance (<2K) stopping C1 charging current. Therefore IC1, wired as an astable multivibrator, starts oscillating at a very low frequency and after a period of about 24 sec. its output pin (#3) goes high, enabling IC2. This chip is also wired as an astable multivibrator, driving the Piezo sounder intermittently at about 5 times per second. The alarm is activated for about 17 sec. then stopped for the same time period and the cycle repeats until the fridge door closes.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    disco lighting
    Logic Checker
    Amplified Noise Limiter For Sw Receivers Circuit
    The switching power supply for electrocar based on UC3842 is designed
    pdf led matrix cube controller 5x5x5
    single cycle datapath write to register and memory at same time
    amplifier timer
    motorcycle low voltage warning
    model railway short circuit
    Hi-Fi DX Bass circuit
    Wideband Low Noise Amplifier
    100Khz sine oscillator
    BA5173 HT7706 dimming control ASIC



    Top