IO8 Module


Posted on Feb 7, 2014

The bus is connected to the 2G—5 shrouded conenctor N9. The two CAN bus signals are fed into the PCP2551 CAN bus transceiver U2. The output of U2 is fed to the UART transmit and receive signals on the PIC16F688 microcontroller U1. 8-pins of the U1 are connected to 1×3; polarized. 1` male headers. Each pin is connected to one of the anlog inpu


IO8 Module
Click here to download the full size of the above Circuit.

ts on U1. A half size crystal oscillator (X1) is used to provide the reference 20MHz signal. A resonator could not be used since it requires pins 2 and 3 of U1, and pin 3 is needed for a analog input (AN3).




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Sight n sound metronome
    565Sca-demodulator
    Six LED Stereo VU Display
    Low Cost Battery Condition IndicatorCircuit
    8V DC Power Supply With Over Voltage Protection
    charge monitor for 12V car battery circuit diagram
    Amplifier Stages
    4-Bit Computer
    Additional formula LP Recorder increased compensation circuit diagram image HQ
    Available voltage booster 400Vp-p output
    Interface circuit fsk modulation and power lines
    It used to delay the monostable multivibrator circuit diagram of a continuous sequence



    Top