Microchip PIC Serial Port Programmer


Posted on Feb 6, 2014

This is a Simple com port based Microchip PIC microcontroller Programmer, This Programmer is based on JDM programmer. The entire programmer is built around commonly available components you can programe may microcontroller by using this schematic, all you need to do is that find out the data sheet of that mcu you want to program and check the pin


Microchip PIC Serial Port Programmer
Click here to download the full size of the above Circuit.

configration. and the lookfor PIN PGC(clock) PGD(data) Vpp(/MCLR) and the power Vss And Vdd like shown in the image blow. To be able to send hex file from your computer to PIC microcontroller you will need to download and install Windpic 800. After the installation, the first thing you will need to do is configureWinpic to work with ourPIC Programmer. To do this go to "Setting" menu and select "Harware setting". The following window will be shown and highlighted areas show you exactly which options should be selected. Now Just connect you programmer circuit to the com port Click on hardware test button in the tool bar, if hardware test is okey then clickon just right side button`detect device` as soon as your devide is detected. now you are all set to open youhex file and load in to the mcu. to start programmingpress the Programall Buttonin the tool bar. wait for a while to finish the programming. when the programming is going on the ledmust beglowing.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Analog Mains Frequency Meter
    Telephone Remote control
    Audio 5 Band equalizer using IC BA3812L
    60MHz Frequency Meter / Counter 10Hz to 60MHz
    MicroFlash Schematic
    Door Lock on Go
    LED-Microscope



    Top