Solar Charger Schematic

Posted on Feb 4, 2014

To take advantage of sunlight shining on the earth can continue to be utilized to serve as a power source so that we can at least save on electricity prices continuing to rise, below is one of a series of simple power plant can be created and used to fill your motorcycle battery or for emergency lights. Sunlight is received by the solar panels are

Solar Charger Schematic
Click here to download the full size of the above Circuit.

then processed into electricity, but electricity generated from each panel is still too small where the 8 Cell Panel arranged in series only mrnghasilkan voltage of approximately 4 volts with a current 200 mA. nah therefore required an electronic circuit to increase the voltage and current enough to be used as a Battery Charger. Electronic Rangakain act as a series of DC to DC Inverter (DC to DC Inverter), which was built by two pieces of Capacitor, Resistor 1, a transistor, a diode, and a coil which is the point of the creation of this series. The circuit was built with a single oscillator system (blocking oscillator) which was built by the transistor and a coil in which the primary winding totaling 45 turns and 15 turns in the secondary as feedback to provide the voltage at the base of the transistor output of the primary winding connected to the diode and used to The battery charging. When the circuit is coupled with the Emergency Neon Lights will certainly get enough voltage to light at night for free. because its batteries during the day in charge by the sun.

Leave Comment

characters left:

New Circuits



Popular Circuits

Headphone Amplifier circuits
Electronic light flasher
Resistance-ratio detector
High quality tone control
Catmans Litterbox
XR2212 PLL FM demodulator Circuit
bluetooth circuit in mobile phones
1w fm booster based 2n4427
Voltage follower with 1G ohm input resistances
Simple Siren Circuit
Power Flashers
Electronic Doorbell with Counter