audio peak detector

Posted on Feb 7, 2014

This audio peak detector allows a pair of stereo channels to be monitored on a single LED. Identical circuitry is used in the left and right channels. Use is made of the switching levels of Schmitt trigger NAND gates inside the familiar 4093 IC. The threshold level for gate IC1. A (IC1. B) is set with the aid of preset P1, which supplies a high impe

audio peak detector
Click here to download the full size of the above Circuit.

dance bias level via R2 (R1). When, owing to the instantaneous level of the audio signal superimposed on the bias voltage by C3 (C2), the dc level at pins 1 and 2 (5 and 6) of the Schmitt trigger gate drops below a certain level, the output of IC1. A (IC1. B) will go High. This level is copied to the input of IC1. C via D2 (D1) and due to the inverting action of IC1. C, LED D3 will light. Network R3-C1 provides some delay to enable very short audio peaks to be reliably indicated. Initially turn the wiper of P1 to the +12 V extreme ” LED D3 should remain out. Then apply line` level audio to K1 and K3, preferably music with lots of peaks (for example, drum n bass). Carefully adjust P1 until the peaks in the music are indicated by D3. The circuit has double RCA connectors for the left and right channels to obviate the use of those rare and expensive audio splitter (Y`) cables.

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    10W 10M Linear Amplifier Circuit
    Build a Crystal Shortwave Radio
    Solar Cell Voltage Regulator
    Ardurino Logger
    simple 555 amplifier
    3v low battery voltage flasher
    interfacing ultrasonic distance sensor ascii pic microcontroller
    Metal detector 8
    12kW PFC Boost Converter
    Atari Joystick USB Adaptor
    Synchronous motor thyristor excitation circuit
    Electric oven circuit
    Pots water alarm circuit