easy melodious door chime circuit explained
#door chime
#melody generator
#sound circuit
#tone generator
#simple audio
#DIY chime
#electronic chime
#home automation
#sound effects
#piezo buzzer
No description available.
Replacing the driver board in an old-school door chime
The doorbell button was replaced with a lighted version, but the chime continued to sound after the button was pressed. These lighted buttons incorporate an incandescent bulb in parallel with the button, a component that has been modified in previous...
Alternate Tone Alarm Circuit
A two-tone generator that is alternately switched ON provides a high/low output similar to that of a traffic vehicle, such as a police car or ambulance. The CD4011 integrated circuit (IC1), which is a quad 2-input NAND gate, functions as...
Sound effects generator (UM3561)
A simple sound generator IC that can produce four sound effects. Designed for use in toys, the effects are selected by varying the connections to pins 1 and 6 as follows. More: A usual toy sounder IC circuit.
The sound generator...
Multi-Instrument Melody Generator UM34811A
This circuit utilizes a preprogrammed multi-instrument melody generator integrated circuit (IC), which features a 512-note memory capable of producing 16 distinct tunes. The extensive control options allow for the playback of all tunes in a loop or stopping at the...
Ding/Dong Door Chime COB PCB ONLY (14pin)
Adjust the component values in the two RC networks to achieve the desired tones. The circuit operates at a 3V low standby current. The kit includes 1 switch, a 1 Watt 8-ohm speaker, 2 AA battery holders, a COB, and...
Sound Effects Generators
The integrated circuit (IC) generates various sound effects, with the output at Pin 3 amplified by a transistor. A 64-ohm loudspeaker can replace the 56-ohm resistor and 8-ohm loudspeaker. A two-pole, four-way switch controls the sound effects, with position 1...
Auto Shut Off Tone Generator
In this auto shut-off tone generator project, connecting the switch to the 9V power supply triggers an alarm that emits a frequency of approximately 1.27 kHz. The alarm remains active for about 170 seconds (or 2.8 minutes) before it stops....
M66T Melody Generator diagram
This is a very simple way to play a song using a single 1.5V battery. This circuit can be built for gift accessories. When the gift is opened, a song will be played. It is easy and inexpensive. The circuit...
Sound-effects-generator
A variable dock-pulse generator consists of two sections of IC1, which is a 4069 CMOS hex inverter, along with resistor R1, switch S1, and capacitors C1 through C6. By adjusting R1 and switching one of the capacitors into the circuit,...