avr Programming an ATmega1284p with Arduino IDE and internal RC Oscillator


Posted on Feb 7, 2014

Program an ATmega1284p with my AVR Dragon and the Arduino IDE. So far I have installed mighty1284p, after writing my sketch. I compile it using the Arduino IDE and then cd into the (temporary) directory the sketch is build in. It contains the. hex file, as seems logic. /* Blink Turns on an LED on for one second, then offfor one second, repeatedly. This example code is in the public domain. */ // Pin 13 has an LED


avr Programming an ATmega1284p with Arduino IDE and internal RC Oscillator
Click here to download the full size of the above Circuit.

connected on most Arduino boards. // give it a name: int led = 1; // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(led, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(led, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second } #include #include #define F_CPU 1000000 int main (void) { DDRB = 0xff; while(1) { PORTB |= (1<




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Track-and-hold
    headphone circuit
    three rails regulated power supply
    Simple Circuit Interfaces 1-Wire Temperature Sensor To A Microcontroller
    Symmetric Output for USB Audio DAC
    IC rprecision waveform generator with sweep and frequency modulation



    Top