basic oscillator circuit using two


Posted on Feb 6, 2014

This is the schematic diagram of basic oscillator circuit which using two transistors. When two transistors and a couple of passive components are connected as shown in the figure, the circuit starts to oscillate. The frequency of oscillation can be adjusted by changing the values of either the resistor or the capacitor. For easier experiment, you


basic oscillator circuit using two
Click here to download the full size of the above Circuit.

may replace the resistor with 10K potensiometer. By increasing its frequency to a suitably high level, it can be used to drive a speaker or a buzzer to produce an audio alarm note. By sufficiently reducing its frequency, the circuit may be used to flash a LED as a warning indicator. Make a PCB in very easy steps. ! Create your PCB design using PCB designer software like Eagle, print out your design on photo paper or glossy paper with laserjet printer. Stick the printed design on the PCB (copper side) and then heat it using hot iron plate. The ink will stick on the PCB and it will be ready for etching process. Note: If you don`t have laserjet printer, then you can print the design on standard paper. Copy the printed design at Copy Service around your location (with glossy paper).




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Dynamo Current and Voltage Regulator
    Low frequency divider
    Voltage-ratio-to-frequency-converter
    Video Line Bar Generator Circuit
    linearize single arm wheatstone bridge output
    electronic timer with display circuit
    Musical keyboard as a signal generator
    LED sequencer



    Top