birdie doorbell circuit


Posted on Feb 5, 2014

This is a design circuit for a doorbell. This circuit can produces a sound like bird sound. This circuit controlled by transistor NPN. This is the figure of the circuit. The operation of the circuit is beginning when P1 is of experimental value. Start with 220 Ohms or so and modify to suit your needs. The transistor is a general purpose kind and i


birdie doorbell circuit
Click here to download the full size of the above Circuit.

s not critical, almost any PNP type will work. L1 is a bell-transformer which is usually already present in the house. If you wish, you could use a battery instead of the bell transformer. Just hookup a 9-volt battery (or wall adapter)to points `A` and `B` (A=+) the diode (D1) is to protect the circuit from accidental polarity reversal and is optional, but required as a rectifier for use with the bell transformer. The transistor T1 is a General Purpose PNP transistor and probably anything will work. L2 comes out of an old am transistor radio. They look like miniature transformers and are usually colored red or green. You have to fiddle with different transformers as the sound can vary depending on the value. The loudspeaker is a 8 Ohm type and must be larger than 200milli-Watt. I used a 2Watt type, but anything over 0. 2W will do.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Adaptor for the Dreamcast serial port
    Components Tester with AT89C52
    TDA1524 Stereo Tone Control
    AttoBasic
    Beat Balance Metal Detector
    RS232 reciever schematic
    A sine-cosine generator
    A Simple Sine Wave Oscillator
    hv neon lamp multivibrator
    EUA2032 Low EMI Ultra-Low Distortion 2.5-W Mono Filterless Class-D Audio Power Amplifier
    lf286 Linux USB LCD display with watchdog and buttons
    simple sound to light converter schematic
    Improved Anode Circuit Parasitic Suppression for Modern Tubes
    8 NC temperature adjustment



    Top