car battery charger


Posted on Feb 7, 2014

This charger will quickly and easily charge most any lead acid battery. The charger delivers full current until the current drawn by the battery falls to 150 mA. At this time, a lower voltage is applied to finish off and keep from over charging. When the battery is fully charged, the circuit switches off and lights a LED, telling you that the cycl


car battery charger
Click here to download the full size of the above Circuit.

e has finished. The circuit was meant to be powered by a power supply, which is why there is no transformer, rectifier, or filter capacitors on the schematic. There is no reason why you cannot add these. To use the circuit, hook it up to a power supply/plug it in. Then, connect the battery to be charged to the output terminals. All you have to do now is push S1 (the "Start" switch), and wait for the circuit to finish. The first time you use the circuit, you should check up on it every once and a while to make sure that it is working properly and the battery is not being over charged.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Dark-activated 230V Lamp
Model Aeroplane Navigation Strobe
Fet Buffer for amplifiers
Arduino Make your own hardware
3 phase ac motor speed control circuit
time delay relay circuit
Capacitor Meter Circuit
Wiring schematic for 2005 636 Kawasaki
Put That Light Out
13.8V 20A linear power supply
Bandwidth broadband linear detector circuit schematic of 10MHz
Automatic volume change with the ambient noise control circuit



Top