WAVEFORM PEAKS AND TROUGHS
#waveform
#peaks
#troughs
#signal analysis
#measurement
#oscilloscope
#voltage
#frequency
#analog
#electronics
No description available.
Oscillator circuits
For successful circuit-building exercises, follow these steps: Measure and record all component values before constructing the circuit, selecting resistor values that are sufficiently high to minimize the risk of damaging any active components. In case of significant errors (greater than...
four channel oscilloscope
This circuit allows the simultaneous display of four signals using only one channel of an oscilloscope. It sequentially switches each input to the output while performing some signal conditioning. This configuration is designed for low-frequency signal measurements and lacks over-voltage...
ProfiLab-Expert 4.0
The ProfiLab-Expert software allows you to develop your own digital or analogue measuring technology projects. It doesn't matter if you want to create analogue measurements or digital controls - you can realize it all. And for all this you don't...
Oscilloscope-preamplifier
This circuit provides approximately 20 dB of voltage gain with a frequency range from 0.5 to 50 MHz. The low-frequency response of this circuit can be extended by increasing the value of the 0.05 µF capacitor or by removing the...
Mini Oscilloscope schematic
Probably the best advantage is its very small size and the fact that it can run off the power supply of the circuit being tested. Although it has a low frequency range, it can still be used for most circuits....
Simple Circuit to Turn your Oscilloscope into a TDR
This simple circuit allows the use of an oscilloscope as a Time Domain Reflectometer (TDR). The operation involves sending a pulse down a cable and observing the resulting reflections.
The circuit design for utilizing an oscilloscope as a Time Domain Reflectometer...
Frequency-Ratio Monitoring Circuit
This circuit generates an output frequency that is linearly proportional to the ratio of two input frequencies. Each pulse of the bias frequency will open a switch for a period equal to half of the second input frequency, allowing a...
Analog-peak-detector-with-digital-hold
Analog peak detection is achieved by repeatedly measuring the input signal with an A/D converter and comparing the current reading with the previous reading. If the current reading is larger than the previous one, the current reading is stored in...
Analog IO Protection
The I/O Filter Wildcard offers an efficient platform for prototyping analog circuits or for filtering, conditioning, or protecting the I/O lines of other Wildcards. It features twenty-four I/O lines that can be independently filtered or combined in customized configurations. To...