AVR 7 Segment Clock Schematic
#AVR
#7 segment display
#clock
#schematic
#microcontroller
#timer
#LED
#digital display
#real-time clock
#electronics
No description available.
Ranco ETC-211000 uses AVR Atmega16L8
The Ranco ETC-211000 utilizes an Atmega16L8 microcontroller. The chip comes with initial protection, necessitating an erasure before any code development can occur. The design has significant flaws, potentially ranking among the worst encountered during reverse engineering efforts, which span over...
LED Chaser
General There are many 9V chaser circuits that seem to waste about 7V when driving LEDs that are only about 2V. This project is unique, because it uses only two inexpensive alkaline battery cells totaling 3V for power. Since most...
Simple AVR Programmers
These are simple AVR programmers. I designed and built four different programmers for various environments: LPT controlled parallel programmer, LPT controlled ISP adapter, COM controlled ISP adapter, and COM controlled generic SPI bridge. Additionally, COM controlled adapters can be used...
BarGraph Ccts
The LED meter is simpler and smaller than its analog counterpart and is commonly found in audio equipment. This version utilizes a National Semiconductor integrated circuit (IC) and employs a logarithmic scale. Each LED operates with a 3 dB difference...
gear display
A universal digital gear display that can be installed on any motorbike. This is a low-cost solution based on simple TTL digital technology without software programming.
The universal digital gear display is designed for easy installation on a variety of motorbike...
AVR Color Clock
This page describes a color clock that displays the time using two RGB LEDs, one for hours and one for minutes. It uses standard color coding for components, with two additional colors to accommodate the twelve distinct color representations needed....
Flashing-LED Battery-Status Indicator Circuit
A battery-status indicator circuit is useful for monitoring portable test equipment and similar devices. LED D1 flashes to attract the user's attention, signaling that the circuit is operational, preventing it from being left on unintentionally. The circuit produces approximately two...
A Light Operated Repeating Timer Circuit
This circuit closely resembles Repeating Timer No. 2. However, the inclusion of a light-dependent resistor (LDR) allows the timer's operation to be confined to daylight hours. Resistor R7 enables the adjustment of the light level at which the timer will...
LED flashing with 3909 IC circuit
This project uses a 3909 IC and a few other parts; power is 1.5 volts DC.
The project employs the 3909 integrated circuit (IC), which is a versatile component commonly used in various electronic applications, particularly in timer and oscillator configurations....