mini drill speed regulator


Posted on Feb 5, 2014

With an integrated voltage regulator connected reverse to a mini drill can be adjusted speed within certain limits so that it remain constant, independently of load. In the scheme presented below the electronic speed control is made by a voltage regulator, allowing use of motor which require a supply voltage from 2. 5 V to 12 V at a maximum current absorbed


mini drill speed regulator
Click here to download the full size of the above Circuit.

by an 1A. Output voltage is determined by the ratio of resistances R1 and R2. Uout = (R1 + R2) Uc/R2. Uc is equal to -2. 23 V for 79GU voltage regulator. With the P2 potentiometer can be adjusted the degree of coupling (coupling the output voltage increases with increasing output current). Thus remains constant preset speed. Maximum voltage measured when the P2 is turned up must be about 20% lower than the maximum allowable voltage of the motor (if is not, the value of R1 should be reduced or enlarged accordingly). Voltage regulator is designed with thermal protection, but it must be mounted on a properly dimensioned radiator.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Free energy battery charger
Stabilized DC Power Supply with Short-Circuit Indication
positive negative probe with ic 555
Simple Logic Probe
Frequency meter - LC measuring instrument
Ensemble II VHF RX
Homemade infrared automatic door controller circuit



Top