Simple Current-to-voltage converter circuit Diagram
#op-amp
#current-to-voltage
#converter
#signal conditioning
#transimpedance amplifier
#analog circuit
#sensor interface
#electronics
No description available.
Dark Seeker - TV-to-Scope Converter
The VGA-to-Scope converter schematic has been simplified by removing op-amp buffers and inverters. A 1 Megohm potentiometer can be used instead of a continuous current supply to charge the capacitor from a 5V source. Proper placement of the potentiometer allows...
Sine-Wave/Square-Wave Converter
An operational amplifier (op amp) configured as a comparator generates a 10-V peak-to-peak square wave output with a 100-mV input signal, operating up to 15 kHz. Adjust resistor R5 to achieve symmetry in the square wave at low input levels.
The...
Room Noise Detector Schematic Circuit
This circuit is designed to signal the exceeding of a fixed threshold in room noise through a flashing LED. Three fixed levels are selectable: 50, 70, and 85 dB. Two operational amplifiers provide the necessary gain for sounds captured by...
Op Amp based Hartley oscillator
Construct an oscillator that meets several specifications. The primary requirement is to incorporate exactly one capacitor. Another requirement is to achieve a high quality factor (Q) and produce a sine wave output. The design under consideration is Hartley’s oscillator, which...
Compound Op Amp Vco Driver
This circuit produces a 5 to 25 V output to drive a voltage-controlled oscillator (VCO) from a standard ±15 V supply system. Resistor R7 and capacitor C1 provide frequency compensation. Transistors Q1 through Q3 form an inverting amplifier with a...
Power Function Circuit
It is possible to easily generate various non-linear functions such as X^(1/2), X^2, X^3, 1/X, XY, and X/Y using logarithms. In this context, division is transformed into subtraction, while multiplication is converted into addition.
The application of logarithmic properties in electronic...
op amp Flow of current in a simple inverting amplifier circuit
Considering a simple circuit as illustrated below, when the voltage source activates suddenly (changing from 0V to 1V), current will flow through the resistor R1. Assuming an ideal operational amplifier (op-amp) that draws no current, and an ideal voltmeter that...
Continuity Checker
U1 is an operational amplifier used as a comparator. When the test probes are shorted together, resistors R1 and R2 bias the non-inverting input to half the supply voltage. The inverting input is biased by a voltage divider that consists...
Phantom Wah for guitarists
This is an op-amp implementation of a Vox style wah, with the inductor replaced by a gyrator circuit. With the component values given the frequency response is similar to a standard wah. By replacing one of the resistors with a...