ratiometric hall effect
#hall effect
#ratiometric
#magnetic sensor
#position sensing
#current sensing
#analog output
#sensor interface
#linear sensor
No description available.
Hall Effect Sensors Magnetic Field
The Hall Effect sensor generates a voltage that is proportional to the strength of the magnetic field it detects. This sensor consists of a silicon layer with two electrodes on either side. In the absence of a magnetic field, the...
Self Powered Current Sensing
This is a current sensing circuit that measures the current on the high side, positioned between the load and the positive supply. This circuit takes advantage of...
A current sensing circuit serves a crucial role in monitoring the flow of electric...
Car lamp failure detector
In Fig.1 see a DC current sensing switch, in which the current is applied from an 8 to 16 Volt supply. The R1 value is chosen so that it generates roughly 100 mV at the required trip current. In Fig....
Is there a simpler solution for highside current sensing here
The loads consist of two or more solenoids connected in parallel, sharing a 12V supply. Each solenoid is individually switched to ground through the vehicle's ECU. The objective is to detect when any one of the circuits closes, ensuring that...
Current sensing relay
It operates by PWM (Pulse Width Modulation) - well, actually by PFM - Pulse Frequency Modulation. At power up, C1 charges up via D1 and R1. R2 will conduct, pulling the base of the emitter follower, Tr2, up and feeding...
Stud-finder
The CS209 is designed to detect the presence or proximity of magnetic metals. It has an internal oscillator that, along with its external LC resonant circuit, provides oscillations whose amplitude is dependent upon the Q of the LC network. Close...
Sense automobile high-side current with discrete components
This design concept originated from the lack of access to advanced integrated circuits (ICs) that are capable of sensing current. A discrete circuit was required that could be easily constructed while still maintaining accuracy comparable to that of modern ICs....
simple gauss detection switch
An ultra-sensitive gauss meter circuit schematic serves as a simple indicator with no measurement, scaling, or accuracy. It consists of a Hall effect device or integrated circuit on a board with power supply inputs, minimal signal conditioning comprising approximately a...
Circuit to convert a voltage output of a Hall device to a current
The proposed approach would dissipate (12V)(3A) = 36 watts, which results in significant heat generation in the circuit. This necessitates consideration of two alternatives: 1) Operating the op-amp at a lower supply voltage, if feasible, or 2) Utilizing a Class-D...