Simplest atmega8 programmer Using LPT Port


Posted on Feb 6, 2014

Atmega 128 is like other AVR microcontrollers. They are ISP is in-system programmable. Earlier I wrote an article about AVR ISP programmer where 74HC244 buffer is used. Using buffer is safer for your AVR. But what if you need 128 atmega programmer without any parts, then you can connect your microcontroller directly to LPT port or use protecti


Simplest atmega8 programmer Using LPT Port
Click here to download the full size of the above Circuit.

on resistors (220R) just in case. of course circuit works without resistors, but you put your LPT port at risk. Just connect GND, SCK, MISO, MOSI and RESET to adequate LPT pins and you can program atmega`s flash memory without removing it from socket. Programming software can be PonyProg. you also need power supply 5v Vcc For IC. if you Using PonyProg make sure the setting like this.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

8 Watt Amplifier
Variable Fan Controller
Flashing LEDs toy with 555
Arduino IR Transmitter & Receiver w/ LEDs Flickering Issue (Whats wrong with this circuit?)
Square Wave Generator
Car battery charger



Top