Advertisement

A 1.2V 130nm CMOS parallel continuous-time ADC for OFDM UWB receivers

Not rated 13,534

#CMOS #ADC #OFDM #UWB #receiver #continuous-time #parallel #130nm #1.2V
A 1.2V 130nm CMOS parallel continuous-time ADC for OFDM UWB receivers
A 1.2V 130nm CMOS parallel continuous-time ADC for OFDM UWB receivers

No description available.


Related Circuits
CMOS interface circuit and the switching amplifier circuit
CMOS interface circuit and the switching amplifier
If the CMOS circuit load (actuator) is a relay device, the circuit must have a large load capacity. Non-gate drive switching amplifiers are connected to a separate element shown in the interface circuit. In the context of a CMOS circuit where...
15V liquid crystal display circuit
1.5V liquid crystal display circuit
The Motorola company's MC14440 CMOS integrated circuit is designed for timing and displaying calendar functions. It utilizes a 32.768 kHz NT cutting type quartz crystal along with fine-tune capacitance to generate time-based signals. The display circuit operates on a 1.5...
Rfrxd0420 Ask Receiver Reference Design circuit
Rfrxd0420 Ask Receiver Reference Design
The RFRXD0420 and RFRXD0920 are low-cost, compact, single-frequency short-range radio receivers that require only a minimal number of external components for a complete receiver system. The RFRXD0420 operates within the frequency range of 300 MHz to 450 MHz, while the...
Cmos-flasher circuit
Cmos-flasher
This circuit utilizes a low-cost CMOS integrated circuit (IC) to control four light-emitting diodes (LEDs), turning them on and off at a frequency determined by the resistor values R1 and R2, as well as the capacitor values C1 and C2....
receiver architectures circuit
receiver architectures
Various architectures of receivers have been proposed in literature, but the most popular architectures among them, such as Heterodyne, Homodyne, Wideband-IF, and Low-IF, are presented here. The Heterodyne receiver architecture utilizes two frequencies: the incoming radio frequency (RF) signal and a...
Cmos programmable divide-by-n counter circuit
Cmos programmable divide-by-n counter
A single connection change allows division by any integer between 2 and 10. The RCA CD4017A Johnson decade counter is configured as a divide-by-7 counter. A resistor is utilized to maintain the reset line in a low state. When the...
current reuse enhances uwb lna circuit
current reuse enhances uwb lna
This broadband low-noise CMOS amplifier operates within the ultrawideband (UWB) communications frequency range of 3.1 to 10.6 GHz, utilizing current-reuse techniques. The broadband low-noise CMOS amplifier is designed to enhance signal integrity and minimize noise within the specified UWB frequency range....
Oscillator Buffers circuit
Oscillator Buffers
CMOS buffers added to an operational amplifier oscillator enhance performance, primarily due to the asymmetry and variability of the operational amplifier's output saturation voltages. The integration of CMOS buffers into an operational amplifier (op amp) oscillator circuit serves to significantly improve...
Cmos 555 astable generates square waves circuit
Cmos 555 astable generates square waves
A CMOS timer generates true square waves because, unlike the bipolar 555, its output swings from rail to rail. The component values shown give a frequency of about 400 Hz. The CMOS timer circuit operates by utilizing complementary metal-oxide-semiconductor technology to...