telephone call voice changer


Posted on Feb 6, 2014

This design fulfills these requirements by means of a variable gain microphone preamplifier built around IC1A, a variable steep Wien-bridge pass-band filter centered at about 1KHz provided by IC1B and an audio amplifier chip (IC2) driving the loudspeaker. 1) The pass-band filter can be bypassed by means of SW1A and B: in this case, a non-manipulat


telephone call voice changer
Click here to download the full size of the above Circuit.

ed microphone signal will be directly available at the line or loudspeaker outputs after some amplification through IC1A. 2) R3 sets the gain of the microphone preamp. Besides setting the microphone gain, this control can be of some utility in adding some amount of distortion to the signal, thus allowing a more realistic imitation of a telephone call voice. 3) R9 is the steep control of the pass-band filter. It should be used with care, in order to avoid excessive ringing when filter steepness is approaching maximum value.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Metal Detector
Energy Saver Relay Coil circuit and explanation
Negative Charge Pump with Ring Oscillator
heart rate monitor schematics
Video Signal Amplifier
UNIVERSAL BATTERY CHARGER
AC contactor DC capacitive circuit a run
Boost has a frequency characteristic of automatic offset MAX630 power conversion
Extend current application circuit



Top