Light-controlled-one-shot-timer

This circuit utilizes the CA3290 BiMOS dual voltage comparator to detect variations in the current of a light-emitting diode (LED). The output from the comparator triggers A2, a one-shot timer. If the light source to the photodiode is disrupted, the circuit output transitions to a low state for approximately 60 seconds.

The circuit's primary function is to monitor the current flowing through the photodiode, which is sensitive to changes in light levels. The CA3290, known for its low power consumption and high-speed operation, serves as the core component for voltage comparison. When the light intensity falls below a predetermined threshold, the comparator's output changes state, signaling that the light source has been interrupted.

Upon the comparator's output indicating a low state, the one-shot timer (A2) is activated. This timer is designed to produce a single output pulse of a specified duration—in this case, approximately 60 seconds. The timing is typically set using an external resistor-capacitor (RC) network connected to the timer. This pulse duration can be critical in applications where a delay is required before taking further action, such as activating an alarm or switching on a backup light source.

The circuit's output can be connected to various downstream components, such as microcontrollers or relay drivers, depending on the intended application. The use of a BiMOS comparator allows for the integration of both analog and digital signals, enhancing the circuit's versatility in a range of electronic systems. Overall, this design is effective for applications where light monitoring and response are essential, such as in security systems or automated lighting controls.This circuit uses Al of the CA3290 BiMOS dual voltage comparator to sense a change in light diode current. A2, a one-shot timer, is triggered by the Al output. If the light source to the photodiode is interrupted, the circuit output switches to a low state for approximately 60 s. 🔗 External reference