Halogen-lamp-dimmer


Posted on Dec 24, 2012

This circuit is suitable for fitting into slide projectors without a dimmer facility as witb 24-Vac fed halogen lamps. With a few small alterations, it can also be used for dimming 12-V halogen lamps, but not those in a car, because these are fed from a de source. The circuit shown in Fig. 50-1a is intended for operation from a 24-Vac supply, and can handle a lamp load of up to 150 W. For loads up to 250 W, the TIC236 should be replaced by a TIC246.


Halogen-lamp-dimmer
Click here to download the full size of the above Circuit.

Figure shows detail of the connection of a potentiometer to the intensity control input of the TCA280A. Voltage divider RlO-Pl-Rll is fitted externally and can be fed from tbe stabilized voltage available at pin 11 of IC1. The minimum and maximum intensities of the lamp are determined by RlO and Rll, respectively.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Car rear Stop Light Flasher
Noisy-signals-filter
switching power supply 4
charging circuit
Low Cost, 16Hz - 100kHz Sine-wave Generator circuit
TDA1029 audio signal source switch circuit diagram electronic project
DC Analysis of a MOSFET Transistor Circuit
picsoft
Capacitance compensation circuit diagram of a power protection



Top