Strobe 12 volt


Posted on Aug 12, 2012

This circuit will give provide a Good Strobe Effect for a variety of Portable Uses. Nominal current draw is `up to about` 1 amp at 12 volts. Depending on value of capacitor on pin 2 of the 555 and the particular choke that is used.


Strobe 12 volt
Click here to download the full size of the above Circuit.

L1 is a 125 Uhy choke, rated at 3.5 amps. It is possible to substitute other chokes, but they must be capable of at least a 1 amp rating. Inductance value isn't too critical. Anywhere between 100 and 500 Uhy. should work fine. Of the ones I tested, this o




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Ultrasonic / Bat detector
Timer circuit
2 Transistor Mini FM Transmitter
arduino How to make a clean amplified microphone analog to digital conversion
galaxi digicolor 26 chassis ittsel
Mains operated LED night lamp
Water Meter Monitor
Electrical Single Line Diagram - Part Two
2003 monte carlo: low idling it cuts off park dash lights
10 Hz to 10 Khz Voltage Controlled Oscillator
Auto Cutter mill circuit



Top