Oscilloscope-preamplifier


Posted on Jun 10, 2012

This circuit provides about 20 dB voltage gain with a frequency range from 0.5 to 50 MHz. You can extend tbe low-frequency response of this circuit by increasing tbe value of the 0.05-ILF capacitor- or try removing tbe capacitor. This circuit delivers a particularly small level of input noise, measured at approximately 20 p.V over a bandwidth range of 15 MHz.


Oscilloscope-preamplifier
Click here to download the full size of the above Circuit.

Calibrate the gain by adjusting tbe gain potentiometer connected between pins 3 and 10, tben adjust the 1-KO trimmer potentiometer for an exact voltage gain of 10; this helps preserve the -vee· -svoc scale factor of the oscilloscope.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Metal Detector DIY
test beeper for audio amplifiers
MMCC-1 :Crystal/Resonator
4 channel dimmer
Fun with Arduino
1-Wire Barometer Calibration
Only one-way operation of the automatic control circuit of the motor
TDA2009 single power amplifier circuit diagram



Top