Hf Broadband Antenna Preamp Circuit


Posted on Dec 6, 2012

The HF/SW receiver preamplifier is comprised of a broadband toroidal transformer (LI-a and Ll-b), LC network (comprised of a 1600-kHz, high- pass filter-and a 32-MHz, low-pass filter), L2 and L3 (26 turns of #26 enameled wire wound on an Amidon Associates T-50-2, red, toroidal core), a pair of resistive attenuators (ATTN1 and ATTN2), and a MAR-x device.Shown here is the composition of a basic 1-dB pi-network resistor antenuator.


Hf Broadband Antenna Preamp Circuit
Click here to download the full size of the above Circuit.

This is the method of supplying dc power to a preamplifier using only the RF coax cable.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

µCurrent Adaptor for multimeters
2 LED flasher with two 2N3904 transistors
Stereo Audio Amplifier 2x2W or mono 5W ( TEA2025 )
Power Amplifier 2x30W
High frequency crystal oscillator
S1Ngle-Ic Logic Probe
schematic 1 3 volt power source
mosfet How to switch between a solar panel and battery
c520
Q-Switch Driver
Automated Attendant burglar alarm circuit



Top