Power-line-modem


Posted on Aug 28, 2012

In the 100-kHz application from left to right, the coupling network feeds into the receiver ~section on the bottom of the chip. (The external components are summarized later.) The receive data output is pulled up via RPuLL ~ 10 K!l. A minimum current of 10 mA sets the voltage drop across RpuLL· Another voltage supply, VLoGJc, is shown if the user wants to have the output sent at TTL levels. Across the top is the transmitter section; going from right to left, the oscillator network, the class AB output stage (note feedback resistor RFEEDBAcK) and the drive section.


Power-line-modem
Click here to download the full size of the above Circuit.

The LC values on the oscillator network should match those on the bandpass filter in the receiver. The drive stage feeds into the coupling network and back into the receive section. This enables the on-chip collision detection with listen-while-talking capability. This effect can be cancelled, although the transmitter will still be connected to the receiver.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

VHF/UHF Wideband Portable Dipole
Speech with XR-T5995
FM Transmitter 4Watt
ADM660 Charge Pump Voltage Inverter Circuit Configuration and Datasheet
5v regulated solar cell power supply circuit diagram
Light Activated Day Night Switch Circuit
Amplitude modulation
Triac low output problem
200m fm transmitter simple circuit
power failure alarm circuit
Sony Triniton TV
Three Hour Timer
RF Combo
Monitor circuit diagram with over 555



Top