Telephone-handset-encoder


Posted on May 17, 2012

This encoder uses a single contact per key keyboard and provides all other switching functions electronically. The diode connected between terminals 8 and 15 prevents the output from goitrg more than 1 V negative with respect to the negative supply Vss. The circuit operates overthe supply voltage range from 3.5 V1o 15 Von the device side of the bridge rectifier. Transients as high as 100 V will not cause system failure, although the encoder will not operate correctly under these conditions. Correct operation will resume immediately after the transient is removed.


Telephone-handset-encoder
Click here to download the full size of the above Circuit.

The output voltage of the synthesized sine wave is almost directly proportional to the supply voltage (V00 -Vss) and will increase with the increase of supply voltage between terminals 8 and 16, after which the output voltage remains constant.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Automatic Bell AT89S8252
Ac-To-Dc Converter
Logic Probe Project
potential difference between point x and point y
logic circuit diagram
Door Bell Circuit Using BEL 188 PCB
Triangular wave generator using Op Amp 741 circuit working and simulated output waveform
UPB1008K NECs LOW POWER GPS RF RECEIVER
Voltage Controlled LFO
FPGA DC Motor Control Circuit
Low Noise Design Schematics



Top