20Db-audio-booster


Posted on Dec 19, 2012

The amplifier`s gain is nominally 20 dB. Its frequency response is determined primarily by the value of just a few components-primarily C1 and Rl. The values in the schematic diagram provide a response of ±3.0 dB from about 120 to over 20,000 Hz. Actually, the frequency response is flat from about 170 to well over 20,000 Hz. it`s the low end.that deviates from a flat frequency response. The low end`s rolloff is primarily a function of capacitor C1, since R1`s resistive value is fixed. If C1`s value is changed to 0.1uF, the low end`s comer frequency-the frequency at which the low end rolloff starts-is reduced to about 70 Hz.


20Db-audio-booster
Click here to download the full size of the above Circuit.

Ifyou need an even deeper low end rolloff, change C1 to a 1.0uF capacitor. If it"s an electrolytic type, make certain that it"s installed into the circuit with the correct polarity-with the positive terminal connected to Q1"s base terminal.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Electrolytic Tester
Temperature Controller With Defrost Cycle
Automatic Light Controller Using 7806
comb filter
transmitter circuit diagram
Distortion In Power Amplifiers
The Measurements for MIT 3DL1 Run
8 channel thermocouple based temperature data logger
Telephone Status Indicator Circuit
DEMODULATOR circuit
motor switch led circuit
Mini FM Transmitter
20 MHz VHF CRYSTAL OSCILLATOR
Breaker control signal circuit of the electromagnetic actuator



Top