Single-tube constant current charger circuit


Posted on Mar 28, 2007

As shown in a practical single-tube constant current charger, which play a constant role transistor VT1, its current value is determined by the voltage regulator and R2. Genera


Single-tube constant current charger circuit
Click here to download the full size of the above Circuit.

l election regulator about 3.3V, resistor R2 taken (30 to 60 Euro)/(1W ~ 2W), when the charge current is about 50mA ~ 80mA. R3 (200 ~ 500 ohms) and LED charging indicator composition circuit is connected as long as rechargeable batteries, LED will glow. If the LED does not light, the battery is bad. The circuit of 1 ~ 4 5 nickel-cadmium batteries, charging time is 12 to 14 hours. Transistor VT1 available 3DD15 or DS11 (plastic) power management, installation, VT1 tube should be added to the radiator. Two kinds of charger neither add charge control circuit should be used to grasp the charging time, in order to ensure safe charging.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

25 Watt MosFet Audio Amplifier
Dc servo bipolar control
voltage transistor loop to limit the current
hall effect switch
LED Bike Light Circuit Project
Very low frequency active filter 5G28 schematic
SHD102 single station to pump water controlled auto-voltage starting circuit a closed
Dynamic expansion circuit improved
Current three-phase motor phase protection circuit diagram



Top