25 Watt MosFet Audio Amplifier


Posted on Feb 21, 2013

Can be directly connected to CD players, tuners and tape recorders. Simply add a 10K Log potentiometer (dual gang for stereo) and a switch to cope with the various sources you need. A correct grounding is very important to eliminate hum and ground loops. Connect in the same point the ground sides of R1, R4, R9, C3 to C8. Connect C11 at output ground. Then connect separately the input and output grounds at power supply ground.


25 Watt MosFet Audio Amplifier
Click here to download the full size of the above Circuit.

Adjust R11 to set quiescent current at 100mA (best measured with an Avo-meter in series with Q8 Drain) with no input signal. Adjust R11 to set quiescent current at 100mA (best measured with an Avo-meter in series with Q8 Drain) with no input signal.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Soft Start For Amps
    30w power amp tda2040 schematic
    avr Programming an ATmega1284p with Arduino IDE and internal RC Oscillator
    Infrared Burglar Alarm Using Remote control PCB
    GlueLogix Technical Services
    22kW and below hoist with Y- transfer power-saving circuit
    Capacitive proximity sensor detection circuit



    Top